NitroStars

For 1/10 scale on and off-road applications also used in the Cen
            racing NX series vehicles
          Standard (non-pilot) short crankshaft
          Two needle rotary carburetor
          Side exhaust
          Seven fin cooling head
          "ABC" cylinder & piston construction "A"luminum piston,"B"rass
            cylinder liner, with a "C"hrome plating on the cylinder
          Three port cylinder liner

This is the NT-16 .16 cu in (2.67cc) Pull Start Engine from Cen Racing.

FEATURES: For 1/10 scale on and off-road applications
          Standard (non-pilot) short crankshaft
          Two needle rotary carburetor
          Side exhaust
          Eight fin cooling head
          "ABC" cylinder & piston construction "A"luminum piston,"B"rass
            cylinder liner, with a "C"hrome plating on the cylinder
          Three port cylinder liner

SPECS:    Horsepower: 5.0hp @ 23,000 T/M
          Displacement: .46 cu in (7.7cc)
          Carburetor Settings: Top End 3 - 4.5 turns out
                               Bottom End: Flush, 1 turn out
                               Idle Gap 1mm
          Distance Between Mounting Hole Centers Same Side:     18mm
          Distance Between Mounting Hole Centers Opposite Side: 44mm
          Width at Mounting Tabs:                               51mm
          Width Below Mounting Tabs:                           35mm
          Height Bottom of Mounting Tabs/Top of Cylinder Head:  107mm
          Height Bottom of Crankcase/Top of Cylinder Head:      124mm
          Length from Starter to Front Bearing:                 95mm
          Length from Starter to End of Crankshaft:             126mm