INCLUDES: HPI Nitro Star G3.0 Engine with Pull Start, instruction manual,
R5 cold glow plug, foam air cleaner assembly with four
zip ties, brass collet
REQUIRES: Fuel: Car blend with 20-25% nitro content
Misc Items: Fuel tubing and track equipment
SPECS: Specs such as horsepower, bore, stroke and RPM were not provided-
contact HPI for further infomation
High Speed Needle Setting: Turn clockwise in 1/8 turn increments
to lean fuel mixture. Do not exceed 2-1/2 turns from flush
Idle Adjustment: Adjust for about 0.04" (1mm) gap between slide valve
and carb body at bore opening
Low Speed Needle: No adjustment recommended
Displacement: .18 cu in (3.0cc)
Distance Between Mounting Holes Same Side: 0.43" (11mm)
Distance Between Mounting Holes Opposite Side: 1.22" (31mm)
Height/Bottom Mounting Flanges to Top of Cylinder Head: 2.99" (76mm)
Height/Bottom of Crankcase to Top of Cylinder Head: 3.5" (89mm)
Length from Pull Starter to End of Crankshaft: 4.13" (105mm)
Length from Pull Starter to Front Bearing: 3.3" (75.3mm)
Length from Center of Crankcase to End of Crankshaft: 2.96" (75mm)
Diameter of Carburetor Bore: 0.21" (5.5mm)
